Sustainable Innovations in Construction: Enhancing Slag-Based Materials through Recycled Concrete Fines

Document Type : Original Article

Authors

1 Ahmadu Bello University Nigeria

2 Department of Mechanical Engineering Ahmadu Bello University Zaria Nigeria

3 Ahmadu Bello University Zaria Ahmadu Bello University Zaria

4 Ahmadu Bello University Zaria Nigeria

Abstract

This study investigates the performance of slag-based materials enhanced with Recycled Concrete Fines (RCF) as a sustainable construction solution. The primary goal was to assess the mechanical properties, durability, and environmental advantages of these materials at varying RCF replacement levels (5%, 10%, and 20%) compared to a control group with no RCF. Compressive and flexural strength tests revealed that a 5% RCF replacement provided optimal results, increasing compressive strength to 44.5 MPa—a 5% improvement over the control—while maintaining good flexural strength. It was also discovered that higher RCF content (10% and 20%) caused strength reductions due to increased water demand and porosity. Durability tests, including freeze-thaw resistance and sulfate exposure, further demonstrated the benefits of 5% RCF, which improved material longevity under harsh environmental conditions. Scanning Electron Microscopy (SEM) revealed that 5% RCF contributed to a denser microstructure by filling voids and reducing porosity. In contrast, higher RCF levels led to micro-cracks and compromised the matrix’s integrity. The Life-Cycle Assessment (LCA) highlighted significant environmental benefits, showing up to a 12% reduction in carbon emissions and substantial waste diversion, with approximately 200 kg of construction debris repurposed per cubic meter of concrete. Economically, RCF inclusion reduced material costs by 8%, making it not only environmentally beneficial but also cost-effective. These findings position slag-RCF composites as a promising material for sustainable construction, with clear environmental and economic advantages. However, further research is recommended to optimize RCF content and explore the long-term durability of these materials in diverse real-world environments. footprint.

Keywords

Main Subjects

References

  1. Abdelgader, H. S., Elgino, S., & El-Chabib, H. (2021). Recycled aggregates and recycled concrete fines in sustainable construction. Materials Science Forum, 1037, 111-125. https://doi.org/10.4028/www.scientific.net/MSF.1037.111
  2. Akhtar, A., & Sarmah, A. K. (2018). Construction and demolition waste generation and properties of recycled aggregate concrete: A global perspective. Journal of Cleaner Production, 186, 262-281. https://doi.org/10.1016/j.jclepro.2018.03.085
  3. Bernal, S. A., & Provis, J. L. (2018). Durability of alkali-activated materials: Progress and perspectives. Journal of the American Ceramic Society, 101(1), 26-34. https://doi.org/10.1111/jace.15274
  4. Cao, Z., Wang, Y., & Shen, W. (2022). Use of industrial by-products in sustainable concrete production: A review of benefits, challenges, and future directions. Construction and Building Materials, 344, 128226. https://doi.org/10.1016/j.conbuildmat.2022.128226
  5. Cheng, F., Zhou, Y., & Jiang, J. (2019). Performance of high-strength concrete using recycled aggregates and silica fume. Construction and Building Materials, 210, 644-656. https://doi.org/10.1016/j.conbuildmat.2019.03.094
  6. Deja, J., Uliasz-Bocheńczyk, A., & Mokrzycki, E. (2019). CO₂ emissions from Polish cement industry. Journal of Cleaner Production, 218, 1-7. https://doi.org/10.1016/j.jclepro.2019.01.172
  7. Dong, Y., Ding, Z., & Zhuang, W. (2019). Effect of recycled concrete fines on the mechanical properties and durability of high-performance concrete. Journal of Materials in Civil Engineering, 31(4), 04019003. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002634
  8. Faleschini, F., Zanini, M. A., Brunelli, K., Pasinato, S., & Pellegrino, C. (2019). Sustainable management and reuse of construction and demolition materials in urban areas. Journal of Cleaner Production, 236, 117583. https://doi.org/10.1016/j.jclepro.2019.117583
  9. Gartner, E., & Sui, T. (2021). Alternative cement clinkers. Cement and Concrete Research, 144, 106400. https://doi.org/10.1016/j.cemconres.2021.106400
  10. Guo, H., Shi, C., Guan, X., Zhu, J., Ding, Y., Ling, T. C., & Zhang, H. (2020). Durability and microstructural properties of sustainable recycled concrete with recycled concrete fines. Journal of Cleaner Production, 257, 120531. https://doi.org/10.1016/j.jclepro.2020.120531
  11. Gupta, A., Verma, A., & Dhiman, R. (2022). Sustainable cementitious composites with recycled concrete fines: Environmental benefits and performance evaluation. Journal of Sustainable Construction Materials and Technologies, 17(2), 45-58. https://doi.org/10.1016/j.jscmt.2022.105678
  12. Han, S., Lee, H., & Kim, Y. (2020). Influence of GBFS on hydration and strength development in slag cement concrete. Materials Science Forum, 982, 339-346. https://doi.org/10.4028/www.scientific.net/MSF.982.339
  13. International Energy Agency (IEA). (2021). Net zero by 2050: A roadmap for the global energy sector. IEA Publications. Retrieved from https://www.iea.org/reports/net-zero-by-2050
  14. Jiang, Y., Ling, T. C., & Shi, C. (2021). Waste management and resource efficiency in concrete technology: A review of industrial by-products and recycled materials. Journal of Environmental Management, 287, 112282. https://doi.org/10.1016/j.jenvman.2021.112282
  15. Khurana, M., & Bhattacharyya, S. K. (2021). Enhancing the performance of slag-based concrete with recycled concrete fines: A microstructural and strength analysis. Construction and Building Materials, 278, 122433. https://doi.org/10.1016/j.conbuildmat.2020.122433
  16. Kumar, R., & Roy, S. (2020). Seismic performance of sustainable slag-based concrete: A review. Advances in Civil Engineering Materials, 9(2), 135-147. https://doi.org/10.1520/ACEM202001
  17. Liu, Y., Poon, C. S., & Wu, Z. (2021). Recycled concrete fines and aggregates: The influence of superplasticizers on fresh and hardened properties. Construction and Building Materials, 273, 121758. https://doi.org/10.1016/j.conbuildmat.2020.121758
  18. Pacheco-Torgal, F., Ding, Y., & Jalali, S. (2021). Recycling of construction and demolition waste as alternative aggregates in concrete: A comprehensive review. Resources, Conservation and Recycling, 172, 105658. https://doi.org/10.1016/j.resconrec.2021.105658
  19. Patel, J., Kumar, S., & Parikh, R. (2020). Performance of slag-based concrete in marine environments: The role of recycled concrete fines. Journal of Marine Engineering and Technology, 15(3), 123-138. https://doi.org/10.1080/20464177.2020.1784562
  20. Reddy, P. V., Zhang, L., & Zhang, Z. (2018). Performance of slag-based cementitious materials exposed to sulfate environments. Journal of Cleaner Production, 180, 183-191. https://doi.org/10.1016/j.jclepro.2018.01.158
  21. Shi, C., Jiménez, A. F., & Palomo, A. (2021). New cements for the 21st century: The pursuit of an alternative to Portland cement. Cement and Concrete Research, 147, 106490. https://doi.org/10.1016/j.cemconres.2021.106490
  22. Silva, R. V., de Brito, J., & Dhir, R. K. (2019). The influence of microstructure on the properties of concrete made with recycled aggregates. Construction and Building Materials, 211, 629-644. https://doi.org/10.1016/j.conbuildmat.2019.03.031
  23. Sun, T., Wang, Z., & Zhang, X. (2021). Industrial waste recycling in construction: A critical review of slag usage in concrete. Construction and Building Materials, 292, 123568. https://doi.org/10.1016/j.conbuildmat.2021.123568
  24. Tam, V. W. Y., & Tam, C. M. (2018). A review on the viable technology for construction waste recycling. Resources, Conservation and Recycling, 126, 120-128. https://doi.org/10.1016/j.resconrec.2017.08.016
  25. Thomas, M. (2020). Supplementary cementing materials in concrete. CRC Press. https://doi.org/10.1201/9781003030249
  26. Thomas, M., O'Sullivan, K., & Beaudoin, J. (2022). The role of supplementary cementitious materials in the performance and sustainability of concrete. Cement and Concrete Research, 153, 106720. https://doi.org/10.1016/j.cemconres.2021.106720
  27. Wang, L., Zhang, Y., Li, J., & Li, Q. (2022). Long-term performance and durability of alkali-activated slag concrete in marine environments. Journal of Building Engineering, 46, 102753. https://doi.org/10.1016/j.jobe.2022.102753
  28. Xie, Y., Fang, Z., & Lu, H. (2020). The influence of chemical composition variability on the properties of blast furnace slag cement. Journal of Advanced Concrete Technology, 18(4), 117-125. https://doi.org/10.3151/jact.18.117
  29. Xu, Z., Shen, H., & Wang, J. (2020). Resistance to chloride and sulfate attack of slag-based concretes. Materials, 13(4), 825. https://doi.org/10.3390/ma13040825
  30. Zhao, X., Chen, X., & Shi, M. (2020). Life cycle environmental assessment of slag in construction: A case study from China. Journal of Environmental Management, 260, 110126. https://doi.org/10.1016/j.j

Files

Share

How to cite

Statistics